X Z
AB5
AA
AB1
Y
V
W
S T E P 10 | CABLE #4 |
Remove the slotted bolt and nut from one end. Thread the opposite end, slotted bolt into the attachment point at the bottom of the main center upright (AB1) a minimum of 0.5”. Tighten the nut against the attachment point. Route the other end through the following pulleys in the order specified: over the front of pulley V, under the back of W, over the back of X, under the back of Y, over the back of Z, and under the back of floating pulley AA. Reattach the slotted bolt and nut. Thread a minimum of 0.5” into the attachment point on the leg press overhead tube (AB5). Tighten the nut against the tube. WA R N I N G :
Failure to thread the ends in the specified distance can result in serious injury!
20
