![](/images/new-backgrounds/1246144/24614425x1.webp)
S T E P 3 WEIGHT STACK
Q05
AK3
K18
AB1
Q05
AK3
•Place weight stack bumpers (Q05) over the holes of both weight stack support blocks (AK3). Place the guide rods over and through the rubber weight plate bumpers into the weight stack support block. Use caution when adding the weight plates. Don’t let the guides tilt too far forward during installation. Slide each of the 20 weight plates over both sets of the guide rods on top of one another. Place the header weight plate over both sets of guide rods on top of other weight plates. NOTE: Place the header plate with the pulley bracket on the leg press side weight stack! The header plate without the pulley bracket will go on press arm side .
•Slide a stopper ring (K18) on the left guide rod of the leg press side and tighten the set screw so the bottom edge of the ring is nine inches from the top of the rod.
•Rest each guide rod behind the top bracket on the main center upright (AB1).
13