![](/images/new-backgrounds/1246144/24614427x1.webp)
AB2
AC1
S T E P 4 | PINK BAG |
• With angled end down and pulley brackets facing weight stack, place the press arm upright (AB2) over the press arm floor support (AC1), aligning the holes in both components. Slide two bolts (M10x62) with flat washers (10.2x22x2) through holes and secure each of the bolts with another flat washer and two nylon nuts (M10).
| • Take the adjustable handle assembly | |
| and slide onto the functional arm upright | |
AH3 | (AH3), making sure the handle is on the | |
side with the numbers. You will need to | ||
| ||
| squeeze the handle to slide over the | |
| adjustment holes in the upright. Place the | |
| functional arm upright (AH3), numbers | |
| facing press arm upright (AB2), over the | |
| exposed bolt ends on the functional arm | |
| floor support (AC2). Secure the connection | |
| with a flat washer (10.2x22x2) and a | |
AB4 | nylon nut (M10) over each bolt end. |
• With the hole for the cable on the bottom, place the leg press upright (AB4) over the leg press floor support (AC3). The upright should angle upwards towards the weight stacks. Align the holes in the upright with the center holes in the floor support. Slide two bolts (M10x62) with flat washers (10.2x22x2) through the connection. Secure each of the bolts with another flat washer and a nylon nut (M10).
AC2AC3
14