Vivotek VS3102 user manual Power on

Power on

Make sure all cables are correctly and firmly connected before turning on VisualServer. Turn on cameras, sensors, alarm devices, and then attach the power adaptor of VisualServer to the electric power socket*. After the POST (power-on self test) is complete and the result is successful, VisualServer is ready for software configuration as described in this manual. At this stage, network speed and video modulation type are automatically detected. If the detection of video modulation fails, administrators may change the setting on the configuration page. Refer to the configuration section for further information.

Connect the power jack of the power adapter to VisualServer prior to plugging the utility end into

the utility power socket. It will reduce accidental electric surge shock.

15

www.vivotek.com

T: 886-2-22404099

F: 886-2-22404097