Vizio VM60P Basic Plasma Hdtv Start Up, Using TV with an Antenna or Cable, First Time TV Use

VIZIO VM60P HDTV User Manual

Chapter 3 Setting Up to Watch Television

For ‘Preparing Your Plasma HDTV for Wall Mounting’, see page 5.

3.1 Basic Plasma HDTV Start Up

1.Connecting the Power Cable

Connect the power cord to the power cord connector on the back of the Plasma HDTV, and then plug the power cord into an AC wall socket.

2.Connect Audio and Video Cables to the Plasma HDTV (see pages 16 ~ 29 for detailed steps)

3.Turning Power On

Once all the components are connected, press the Power ON button on the side of the Plasma HDTV, or press the Power ON (Red) button on the remote control.

4.Select Input Source

Select the Input Source for the Plasma HDTV by pressing the INPUT button on the side of the TV or using the Input button on the remote control. Pressing this button will cycle you through the following options: TV, DTV, AV1 (S-Video or Video*), AV2 (S-Video or Video*), Component 1, Component 2, RGB, HDMI 1, HDMI 2, HDMI 3 and HDMI 4. You can also select them by using the TV, AV, Component and HDMI buttons on the remote.

*S-Video has priority. If a signal is connected to AV1 S-Video by itself or signals are connected to AV1 S-Video and AV1 Video simultaneously, then S-Video will be the only choice for AV1. If a signal is connected to AV1 Video only, then Video will be the only choice for AV1. The same input priority scheme applies to AV2.

3.2 Using TV with an Antenna or Cable

3.2.1 First Time TV Use

If an antenna or cable source is connected to the DTV/TV input, you will need to select TV using the INPUT button on the remote control or the side of the Plasma HDTV, or directly by pressing the TV button on the remote control, and Auto Scan for the available TV channels. The screen will show ‘snow’ and an OSD panel that says, “Channel Scan Required Press Menu.”

Note: If you do not see this option within the OSD, you might have selected the wrong input in the previous steps and you will need to repeat step 4 (above) to select the correct input source.

Version 3/26/2007	30
	www.VIZIO.com