LOG PLACEMENT (3 LOG SET)
Before you begin: If you are installing logs into the BVP42 model then this fireplace is supplied with a set of three ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling logs, wash your hands gently with soap and water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of this fireplace. Sooting and other problems may result if the logs are not properly and firmly positioned in the fireplace. Please refer to Figure 18, Figure 19, and Figure 20 and corresponding WARNING, when completing the following log placement steps.
1.Place bottom log onto main burner. Align holes on bottom log with (4) locator pins on burner.
2.Place rear log on rear log shelf. Place rear log so that the locator holes align with the (2) locator tabs in the log support shelf.
3.Place top branch onto flat area of rear log and over the front of the bottom log.
4.Place decorative rock in front of grates and sides of main burner.
ATTENTION: Do not place decorative rock on logs or on burner. The decorative rock should only be placed on the fireplace floor.
5.After all logs are properly positioned, place small "dime" size pieces of Rockwool lightly across the front round "blue flame" ports. Place the ember material (Rockwool pieces) side by side. Do not stack more than one layer of embers across the burner ports. See Figure 18.
REAR LOG LOCATOR TABS
Figure 19
WARNING: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.
Attention: Do not use Figure 19 or Figure 20 to order logs. Refer to parts view on page 30 and parts list on page 31 to order logs and/or ember material for your appropriate fireplace model.
TOP BRANCH
REAR LOG
BOTTOM LOG
EMBER PLACEMENT
BOTTOM LOG LOCATOR PINS | Figure 20 | |
Figure 18 | ||
|
Page 15 |
