TROUBLESHOOTING
SYMPTOMS |
| POSSIBLE CAUSES |
|
|
|
High Pressure and Low Water lights do | 1. | Electrical power to the steamer is not on. |
not come on when [ l ] is pressed. | 2. | Power switch is not in the [ l ] position. |
|
|
|
Steamer will not fill. | 1. | If the Low Water light is on, the water supply valve |
|
| may be off. Check water supply pressure. |
| 2. | Water filter is plugged. Refer to water filter manual. |
|
| If symptom persists, contact Service. |
|
|
|
Steamer will not heat or build pressure. | 1. | Press Reset to clear any problem modes. |
| 2. | Water supply to the machine is not turned on. |
| 3. | Water filter may be clogged. |
| 4. | Make sure that both valves above and below the |
|
| sight glass are open. |
| 5. | Make sure that the water inlet ball valves are in the |
|
| open position. |
|
| |
Water flows into compartment. | Contact Service. | |
|
|
|
Door leaks. | 1. | Check door gasket for damage. If adjustment is |
|
| needed, contact Service. |
| 2. | Plugged drain or screen. Clear compartment cavity |
|
| screen. If symptom persists, contact Service. |
|
| |
Water accumulates in compartment. | Drain may be clogged. Clear drain. | |
|
| |
Water flows into drain when unit is off. | Contact Service. | |
|
|
|
SERVICE AND PARTS INFORMATION
To obtain service and parts information concerning this model, contact the
When calling for service, the following information must be available: model number, serial number, manufacture date (MD) and voltage.
– 30 –