VXI 320222-01 INTX Trigger Configuration Register (on VXI-MXIs with INTX only)

Chapter 4 Register Descriptions
© National Instruments Corporation 4-27 VXI-MXI User Manual
INTX Trigger Configuration Register (on VXI-MXIs with INTX only)
VXIbus Address: Base Address + 14 (hex)
Attributes: Read/Write
R/W
15 14 13 12 11 10 9
ETRG7EN ETRG6EN ETRG5EN ETRG4EN ETRG3EN ETRG2EN ETRG1EN ETRG0EN
8
R/W
7 654321
ETRG7DIR ETRG6DIR ETRG5DIR ETRG4DIR ETRG3DIR ETRG2DIR ETRG1DIR ETRG0DIR
0
This register on the INTX daughter card is used to configure the mapping of the eight VXIbus
TTL trigger lines to and from the eight INTX trigger lines.
Bit Mnemonic Description
15-8r/w ETRG[7-0]EN Extended Trigger Enable Bits
Setting these bits individually enables the corresponding VXIbus
TTL trigger lines to be mapped to the corresponding INTX trigger
lines, as specified by the corresponding ETRGxDIR bits. Clearing
these bits disables the mapping of the trigger lines to the INTX
trigger lines. These bits are cleared on a hard reset.
7-0r/w ETRG[7-0]DIR Extended Trigger Direction Bits
When the corresponding ETRGxEN bits are set, these bits control
the routing of the INTX trigger lines. When ETRGxDIR is clear,
the corresponding VXIbus TTL trigger line drives the INTX
trigger line. If the ETRGxDIR bit is set, the INTX trigger drives
the corresponding VXIbus TTL trigger line.
ETRGxEN ETRGxDIR Routing
0 X Disabled
10
VXI trigger X drives INTX
trigger line X
1 INTX trigger line X drives VXI
trigger X