VXI Technology, Inc.
ACRYLIC RACK MOUNT DOOR KIT INSTALLATION
An acrylic rack mount door is offered as an alternative to the aluminum rack mount door. The kit (Option 65) provides the necessary hardware to install a 1/8” thick acrylic door in front of the rack mounted chassis. An installation diagram is provided on the following page for ease of assembly. This option requires that the rack mount ear kit also be installed and configured for recessed mounting.
REQUIRED TOOLS
1.#2 Phillips Screwdriver
2.1/8" Flat Blade Screwdriver
3.11/32" Open Ended Wrench
PARTS LIST
QTY | ITEM | VTI P/N |
2 | Screw, | |
2 | Nut, Hex, | |
1 | Latch, Vise Action, Knob Style, Black | |
2 | Hinge, Adjustable Damping, Black | |
4 | Screw, | |
1 | Stop, Front Door, | |
1 | Door, Front, | |
2 | Brace, Rackmount, | |
4 | Nut, Hex, | |
4 | Washer, Split Lock, | |
4 | Washer, Flat | |
4 | Screw, | |
4 | Screw, |
ASSEMBLY PROCEDURE
1.Lay the chassis on a protected work surface on its long side with the voltage monitor LEDs of the chassis facing front with the power switch toward the top.
2.Locate two rack mount (cross) braces. Install one each along the front of the flanges (one on top and one on the bottom) using four (two ea.) #8 flathead screws. The lip along the long edge of each brace goes toward the front and pointing inside. The braces fit over the flanges and the screws are placed from the inside going through the flange and then into the brace.
3.Locate the front door and two hinges. Install the two hinges to the front door using four 1/2” black oxide pan head screws through the holes of the hinge with the flat washer in contact with the door and with the split lock washer between the hex nut and the flat washer.
4.Locate the latch kit and install it into the door from the side where the hinges are mounted.
5.Locate the door latch bracket and install it on the rack mount ear opposite the end where the hinges will be installed. Use the rack mount door installation diagram below as a reference.
28 |
