ADJUSTING THE DISPLAY

FACTORY PRESETS, AUTO-SYNC, AND USER SETTINGS

Factory presets: For optimal display quality, set your video card to Cintiq’s native resolution of 1600 x 1200 pixels (UXGA). See page 63 for signal specifications.

Auto-sync:The auto-sync function automatically sets the horizontal and vertical screen position, as well as clock and phase. When connected as a VGA display, Cintiq attempts to automatically synchronize to the incoming signal. At the native resolution of 1600 x 1200, the vertical refresh frequency must be set to 60 Hz. For other resolutions, auto-sync will function when the horizontal frequency is between 31 to 92 kHz and the vertical frequency is between 56 to 85 Hz. If a specific resolution and vertical refresh frequency are not supported, you will see an “invalid mode” message. In this case choose a different resolution or refresh frequency.

If Cintiq does not automatically synchronize with the incoming signal, you can press the AUTO adjust button to initiate display synchronization. Additional screen display adjustments can be manually made using the OSD controls.

User settings: When you manually adjust the display using the OSD function, the settings are stored within Cintiq for use the next time the unit receives a similar signal. This is applicable to all display modes.

Color calibration: Changing the color, color temperature, contrast, brightness, or backlight from their default settings will invalidate the ICC color profile that was included on the driver CD.

ON SCREEN DISPLAY (OSD) SETTINGS

The OSD function enables you to adjust and optimize a variety of display settings at the touch of a button. The OSD controls are located on the back of the unit. Simply reach over the top of the display unit to locate the buttons with your fingers.

Note: Braille-style dots above the buttons help you to identify each one by touch.

Digital/Analog (DVI/VGA) switch

Up or Down buttons

Press the up or down buttons to toggle between menu options, and to increase or decrease the value of a selected setting.

MENU / ENTER button

Use this button to open the OSD menu and to accept changes you make to the OSD settings.

SELECT / AUTO button

When working with the OSD menu, pressing SELECT chooses the highlighted menu option.

In VGA mode with the OSD menu closed, pressing AUTO performs an AUTO ADJUST of the display.

Customizing Page 35

Page 37
Image 37
Wacom DTZ-2100D manual Adjusting the Display, Factory PRESETS, AUTO-SYNC, and User Settings, On Screen Display OSD Settings