FRAME ASSEMBLY
4.Press a 2” Square Inner Cap (27) into the end of the Top Frame (55). Press a 1 3/4” Square Inner Cap (44) into each end of the crossbar on the Top Frame. Press two 1” Round Inner Caps (49) into the top of the crossbar.
Attach the Top Frame (55) to the Assist Upright (74) and the Leg Press Upright (56) with two 5/16” x 2 3/4” Bolts (11) and two 5/16” Nylon Locknuts (3).
Attach the Top Frame (55) to the Front Upright (42) with two 5/16” x 2 3/4” Bolts (11), two 5/16” Flat Washers (8), and two 5/16” Nylon Locknuts (3).
5.Slide the Rear Seat Frame (100) onto the indicated 5/16” x 2 1/2” Carriage Bolts (1) in the Stabilizer (5).
Do not tighten the Nylon Locknuts yet.
Attach the other end of the Rear Seat Frame
(100)to the Leg Press Upright (56) with two 5/16” x 2 3/4” Bolts (11), two 5/16” Flat Washers (8), and two 5/16” Nylon Locknuts (3).
Attach the Handle (82) to the Rear Seat Frame (100) with two 5/16” x 2 1/2” Carriage
4 | 11 | 49 |
| 55 |
|
8 | 44 |
|
27 |
3 |
44 | Crossbar |
11 | 3 |
|
56 |
|
|
42 | ||
|
|
|
|
|
|
74
5 | 1 |
|
100
11 |
56 | 3 |
|
8 |
3 |
Bolts (1) and two 5/16” Nylon Locknuts (3).
Tighten all Nylon Locknuts used in steps 1–5.
6. Set two Weight Bumpers (19) on the bracket |
on the Base (4) as shown. Set two Weight |
Bumpers (19) on the bracket on the Stabilizer |
(5). |
Stack ten Weights (25) onto the bracket on |
3
1
6
Pin 
Grooves
82
5
the Stabilizer (5). Stack eight Weights onto the |
bracket on the Base (4). Be sure that the pin |
grooves are all on the same side of each |
stack of Weights. |
Be careful not to tip either stack of |
Weights (25) until step 8 is complete. |
25 |
25
19 | Pin | |
Grooves |
19 |
6
