Wells WFGA-60FS TROUBLESHOOTING continued, Symptom, Possible Cause, Suggested Remedy

TROUBLESHOOTING (continued)

SYMPTOM	POSSIBLE CAUSE	SUGGESTED REMEDY
	Switches not set for filtering	Press power switch (item 1) to FILTER
		Press pump filter switch (item 6) to ON
Filter pump will not run	Pump overload (item 17) tripped	Reset overload. Press red button until it
		“clicks” and stays locked in
	Internal damage (pump overload trips	Contact your Authorized Wells Service
	frequently)	Agency for repairs
	Drain valve (item 19) not properly set	Oil level in reservoir must be monitored
		at all times while filtering. Adjust flow by
		opening or closing drain valve
Filter reservoir overflows
	Filter leaf surface clogged with crumbs or	Turn drain valve OFF. When bubbles
during filter cycle	other cooking debris	begin appearing in frypot turn filter pump
		switch OFF. Carefully slide reservoir out
		12” and clear surface of filter leaf with
		hi-temp brush or wooden dowel. Rein-
		stall reservoir and resume filtering.
	Filter leaf not properly assembled or not	Reassemble filter leaf. Be sure o-ring is
	properly installed	in place, o-ring receptacle is clean and
Does not filter completely		filter leaf is properly installed in reservoir.
	Filter leaf screen damaged	Replace filter leaf
	Filter leaf o-ring damaged	Replace filter leaf o-ring
	Suction tube not seated, allowing air to	When inserting filter reservoir be sure
	enter system	suction tube is fully seated in suction line
Filter pump won’t pump, or pumps air		receptacle.
when filtering	Suction tube o-ring damaged	Replace suction tube o-ring
	Internal damage	Contact your Authorized Wells Service
		Agency for repairs
		NOTE: There are no user serviceable
		components in the fryer. In all cases of
		damage or malfunction, contact your
		Authorized Wells Service Agency for
		repairs.

371 301098 OpManual for WFGA-60FS Gas Fryer

30