INSTALLATION (continued)
WARNING
SLIPPING / FALLING HAZARD SPILLED OIL
DO NOT OPERATE UNLESS
THE GREASE CUP
AND TROUGH
ARE INSTALLED.
Oil and moisture will drip onto the floor and falls may result. Death or serious injury may result from slipping and falling
On units with optional frypot drains, be sure drain valves are left in the closed position.
GREASE TROUGH AND GREASE CUP INSTALLATION
1.Install the GREASE TROUGH into the brackets below the grease baffle.
2.Install the GREASE CUP on the right side of the unit, directly below the grease trough.
FRYPOT INSTALLATION
1.Using the lifting handle, raise the element head. The support rod is spring loaded and will move into place to support the head.
2.Install the frypot in the cutout beneath the element head.
3.Lift the element head slightly, then move the element support rod forward to allow the head to lower.
4.Gently lower the element head into the frypot.
ROLL WARMER INSTALLATION
1.Install roll warmer drawers in drawer slides.
2.Place appropriate one drawer insert pan into each warmer drawer. If used, place one Humitrol rack into each drawer pan.
Humitrol
Rack
Drawer
Insert
Pan
Fig. 8a Frypot Drain Valve
Operation
Fig. 8 Roll Warmer Drawer Pan Installation
12