INSTALLATION (continued)
SERVICE TECHNICIAN INSTALLATION NOTES
An Ansul® technician must charge and arm the fire suppression system before the ventilator blower will operate. See page 10.
Installation and start up must be performed by an Authorized Installation Company.
Installer must complete the WARRANTY REGISTRATION form, and record appliance installation particulars on the CUSTOMER SERVICE DATA form in this manual.
Certain codes require cooking equipment to be restrained with a RESTRAINT DEVICE. It is the RESPONSIBILITY OF THE INSTALLER to check with the AUTHORITY HAVING JURISDICTION, in order to ascertain the applicability of this requirement to THIS SPECIFIC EQUIPMENT INSTALLATION. Any restraint device must allow access to the back and sides of the unit to provide for servicing and maintenance, and must not interfere with the operation of the FIRE SUPPRESSION SYSTEM.
IMPORTANT!
Verify that this VENTILATOR and food cooking equipment installation is in compliance with the specifications listed in this manual, with local code requirements, and in accordance with N.F.P.A 96
(THE STANDARD FOR VENTILATION CONTROL AND FIRE PROTECTION OF COMMERCIAL COOKING OPERATIONS - current edition).
THIS IS THE
RESPONSIBILITY
OF THE INSTALLER
ELECTRICAL INSTALLATION
Refer to the nameplate on the cooking appliance to verify the ELECTRICAL SERVICE POWER. Voltage and phase must match the nameplate specifications, and available electrical service amperage must meet or exceed the specifications listed on page 1. Incoming wiring must comply with National Electrical Code specifications.
All 3ø fryer / universal hood appliances (except EU units) ship from the factory with a 3ø cordset.
All 1ø fryer / universal hood appliances; and, all EU fryer / universal hood appliances must be wired directly to the electrical circuit. Most jurisdictions require an approved electrical disconnect to be installed in the branch circuit, in near proximity to the appliance.
Field conversion of 3ø appliances to 1ø is neither recommended nor authorized by Wells Manufacturing Co.
DANGER
ELECTRIC SHOCK
HAZARD
ELECTRIC CONNECTIONS MUST BE MADE BY A LICENSED ELECTRICIAN Electrical shock will cause death or serious injury.
NOTE: This appliance requires a dedicated electrical branch circuit with 50 Amp protection for 3ø; or, 80 Amp protection for 1ø.
IMPORTANT:
Contact a licensed electrician to install and connect electrical power to the appliance.
IMPORTANT: Damage due to being connected to the wrong voltage or phase is NOT covered by warranty.
9
