Wells WVF-886 Troubleshooting Suggestions, Symptom, Possible Cause, Suggested Action

TROUBLESHOOTING SUGGESTIONS

SYMPTOM	POSSIBLE CAUSE	SUGGESTED ACTION
Ventilator blower won’t run	Circuit breaker tripped	Check / reset circuit breaker
Ventilator blower won’t	Ansul® fire suppression system	Contact Authorized Ansul®
run — buzzer sounding	tripped	Distributor for repairs
Ventilator blower runs	Clogged filter , or filter out of position	Observe indicator lights,
momentarily, shuts down.		service filter(s) as required
	Damaged internal components	Contact your Authorized Wells
		Service Agent for repairs
CHECK FILTERS light on	Filter or grease baffle out of position	Reinstall filters / baffle
REPLACE PREFILTER	Pre-filter clogged, but still operational	Replace pre-filter at first
light on.		opportunity
REPLACE FILTER PACK	Filter pack clogged, but still	Replace filter pack at first
light on	operational	opportunity
SERVICE REQUIRED	Prer-filter or filter pack clogged	Replace pre-filter first. If
light on		indicator stays lit, replace filter
		pack
Roll warmers won’t heat	Damaged internal components	Contact your Authorized Wells
(ventilator operational)		Service Agent for repairs
Warmer drawer not hot	Temperature control not set	Set control to desired temp
enough
Product in warmer drawer	Humidity control not set	Set for desired humidity
too dry or wet

NOTE: There are no user serviceable components in the appliance.

A.In all cases of damage or component malfunction, contact your Authorized Wells Service Agency for repairs.

B.For service of the fire suppression system, contact an Authorized Ansul® Distributor.

24