Westinghouse SE 6000 manual Coax OK

C-2			APPENDIX C: SYSTEM TRANSACTIONS — NUMERICAL SEQUENCE
	#	Message	Explanation
	29	Printer On	Log printer switched on.
30		Device Reset	708P / 8xx-series powered up / re-initialized.
	31	Return From Failsoft	708P communication restored — no longer in failsoft mode.
32		Power Failed	708P / 8xx-series with 3708 UPS has lost AC power.
	33	Power Restored	708P / 8xx-series with 3708 UPS has regained AC power.
34		Tamper Active	708P / 8xx-series tamper input active.
	35	Tamper Clear	708P / 8xx-series active tamper input now cleared.
36		COAX Failure	Coax cable from ACU to reader shorted.
	37	COAX OK	Coax cable from ACU to reader repaired.
	38	Sensor Failure	ACU has lost communication with reader (open coax).
39		Sensor OK	Previously failed reader (or open coax) repaired.
	40	Printer Error	Log printer is not functioning properly.
41		Poller Params Reloaded	Host has initialized a poller.
	42	Still Held Open	DOOR HELD OPEN — Second alert message.
43		Input Point Active	A GENERAL input has been activated.
	44	Input Point Normal	Previously activated GENERAL input point has been cleared.
45		Timeout Device	Response from polled ACU by host not received within allotted time
			(usually 2 seconds).
	46	Unable to Lock Door	Host unable to implement automatic or manual command to lock a
			door (error on lock).
47		Unable to Unlock Door	Host unable to implement automatic or manual command to unlock
			a door (error on unlock).
	48	Unable to Clear Output	Host unable to restore output contact to normal (error on output
			clear).
49		Unable to Act. Output	Host unable to restore output contact to active (error on output
			clear).
	50	Not Used	Reserved for future applications.
51		Not Used	Reserved for future applications.
	52	Manual Unlock Timed	Timed unlock command entered.
53		Manual Access Granted	Manual access command issued.