INSTALLATION REQUIREMENTS
Tools and Parts—All Models
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Tools Needed
■ | Phillips screwdriver | ■ | Tape measure |
■ | Scissors | ■ Cordless drill and ¹⁄₈" bit | |
■ | Level | ■ | Pencil |
Parts Supplied
Check that all parts are included in parts package.
A
B
C | G |
| |
D | E F |
| |
H |
|
I |
|
A. Foam seal with adhesive | E. ³⁄₈" screws (4) (5500, 6300 and 8k |
strip | models only) |
B. Foam seal without | F. ³⁄₄" screws (5) (6 provided on 10k and |
adhesive strip | 12k models) |
C. Window lock bracket | G. Side curtains (2) |
D. Side bracket (on some | H. Top channel seal (on some models) |
models) | I. Top channel (on some models) |
Location Requirements—All Models
IMPORTANT: Observe all governing codes and ordinances.
Check the location where the air conditioner will be installed. Make sure you have everything necessary for correct installation.
The location should provide:
■Grounded electrical outlet within 6 ft (183 cm) of where the power cord exits the air conditioner.
NOTE: Do not use an extension cord.
■Free movement of air in room to be cooled.
■A large enough opening for the air conditioner. Installation parts are supplied for
■Adequate wall support for weight of air conditioner. Air conditioner weighs 50 lbs to 75 lbs (22.7 kg to 34 kg).
NOTE: Cabinet louvers must not be obstructed. Air must be able to pass freely through the cabinet louvers.
A
A. Cabinet louvers
Window Installation
Window Opening Measurements—Small Chassis:
5500 Btu, 6300 Btu and 8000 Btu:
■21" (53.3 cm) minimum to 33¹⁄₂" (85 cm) maximum opening width.
■13¹⁄₂" (34.3 cm) minimum opening height
Window Opening
■24" (61 cm) minimum to 36" (91.4 cm) maximum opening width.
■15" (38.1 cm) minimum opening height.
A |
B |
A. Small chassis: 21" (53.3 cm) minimum;
Large chassis: 24" (61 cm) minimum
B. Small chassis: 13¹⁄₂" (34.3 cm) minimum;
Large chassis: 15" (38.1 cm) minimum
4