Electrical Requirements—All Models
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
It is the customer's responsibility:
■To contact a qualified electrical installer.
■To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA
Copies of the standards listed may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169
Power Supply Cord
NOTE: Your air conditioner’s device may differ from the one shown.
The electrical ratings for your air conditioner are listed on the model and serial number label. The model and serial number label is located on the
Specific electrical requirements are listed in the “Power Supply Cord Electrical Requirements” chart. Follow the requirements for the type of plug shown in the chart.
Power |
|
Supply |
|
Cord | Electrical Requirements |
|
|
| ■ |
| ■ |
| ■ |
| ■ If there is a “Single Circuit Only” label on the |
| unit, use on a dedicated |
| only. |
| ■ If a dedicated |
| available, then it is the customer’s |
| responsibility to have a |
| installed by a qualified electrician. |
| ■ If there is no “Single Circuit Only” label on the |
| unit, the unit may be used on any branch |
| circuit of correct voltage and adequate current |
| protection rating. |
Recommended Grounding Method
This air conditioner must be grounded. This air conditioner is equipped with a power supply cord having a grounded 3 prong plug. To minimize possible shock hazard, the cord must be plugged into a mating, grounded 3 prong outlet, grounded in accordance with all local codes and ordinances. If a mating outlet is not available, it is the customer's responsibility to have a properly grounded 3 prong outlet installed by a qualified electrical installer.
A
B
POWER |
| |
|
| RESET |
|
| |
TEST |
A. Test button
B. Reset button
This window air conditioner is equipped with a power supply cord required by UL. This power supply cord contains
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
To test your power supply cord:
1.Plug power supply cord into a grounded 3 prong outlet.
5