Whirlpool DRYERS warranty Problem Check if

PROBLEM	CHECK IF
Shrinking	Items are overdried

Fabric type and quality is suitable for drying

Slow drying	There is a large amount					of
	moisture in the load to be
	dried
	Cold rinse water is used
	Room air temperature				is
	below 45°F (7°C)
	Dryer is exhausted according
	to Installation			Instructions
	Lint screen		is clogged
	Exhaust	duct or outside
	exhaust	hood		is clogged
	Proper	electrical supply				is
	used
Statk	Load is overdried
electrkity
	Fabricsoftenerisused
	Synthetics,		synthetic		blends,

permanent press and knits are in load

CAUSES/SOLUTIONS

Remove items while there is still a trace of moisture. Some items should be removed while damp, then shaped and air dried.

Some knits are stretched during manufac- turing. Washing and drying returns them to the original size. This is normal. Check quality of garment before buying. Follow fabric care label directions carefully.

Some items hold more moisture than others (cottons more than polyester). They take longer to dry. Full loads take longer to dry than small loads of the same fabric.

A load rinsed in cold water will take slightly longer to dry than a warm one. Cold rinses, however, help save energy and reduce wrinkling more than warm rinses do.

Install dryer in a room where the air temperature is warmer than 45°F (7°C). Cold air increases drying time and may cause wrinkles not to be removed.

Install and exhaust your dryer according to the Installation Instructions provided.

Clean lint screen before or after each use.

Clean if needed.

Properly connect the dryer to a grounded electrical circuit that meets the electrical requirements stated in the Installation Instructions.

Remove items while there is still a trace of moisture.

Use a fabric softener and follow package directions carefully.

Synthetics, synthetic blends, permanent press and knits build up static electricity. Use a fabric softener and be careful not to overdry the load.

28