Powerware FE/QFE UPS To start the user test alarm from, Alarm off, System test, Emergency, PwrOff

k	W	W	v h l	v s c
	b	l
J	: – – –	User Test	The user is testing the alarm feature.	To start the user test alarm from the
		Alarm		control panel, press [CTRL]-[8] [ENTER]
				[ENTER]. Repeat the procedure to turn the
				alarm off.

K	– :–	Hi	The transformer temperature is too high. If
		Transfmr	the temperature reaches a preset point, the
		Temp	UPS shuts down.

The UPS may have shut down; if so, contact your service representative. If the UPS has not shut down, shut down your equipment or bypass the UPS; then, turn the UPS off and contact your service representative.

L	: – : :	Check	The UPS has detected a charger problem.	Contact your service representative.
		Charger
M	– –	Check	The batteries have failed the automatic	Contact your service representative.
		Battery	system test.
N	– :	Check	The inverter has failed the automatic	Contact your service representative.
		Inverter	system test.
O	– – –	Memory	Possible microprocessor problem.	Shut down your equipment or bypass the
		Check		UPS; turn off the UPS. Contact your service
				representative.

P	: – – :Emergency	The Remote Shutdown feature has been
	PwrOff	activated at the RS-232 port (see “Remote
		Shutdown” on page 47.)

To restart the UPS, disconnect the signal to Pin 21 on the RS-232 port. If you have a control panel, put the UPS in Auto mode. If not, turn the On/Off switch off and then on again.

Q	– – :–	Hi PFM	The Power Factor Module’s temperature is
		Res	too high. If the temperature reaches a
		Temp	preset point, the UPS shuts down.

If the UPS has shut down, contact your service representative. If not, shut down your equipment or bypass the UPS; then, turn the UPS off and contact your service representative.

R	: – :	Probe	A temperature probe is missing or	The UPS may shut down. Contact your
		Missing	damaged.	service representative.
S	: : :	High AC	The input voltage is higher than the alarm	Contact your service representative.
		Input	setting.

Powerware® FERRUPS FE/QFE UPS (500 VA–18 kVA) User’s Guide : Rev A www.powerware.com 61