Table 2. Indicator Status
h | r | d |
|
|
|
AC LINE | On | TheNOTEUPS is getting power from the AC input power source. |
|
| The AC LINE indicator does not illuminate for FE models with serial numbers |
|
| 25000 and greater until the UPS ON/OFF switch is turned to the ON position. |
| Off | : The UPS is not getting input power. |
|
| : There is a power outage. |
|
| : The AC input breaker is tripped. |
|
| : The UPS is unplugged. |
|
| : For FE models with serial numbers 25000 and greater, the ON/OFF switch is not in |
|
| the ON position. |
| Flashing | Not applicable. |
|
|
|
READY | On | The UPS is ready to provide battery backup power when needed. |
|
|
|
| Off | The UPS cannot provide battery backup power because: |
|
| : It is in the Line Condition mode or the Off mode (see “Using the Control Panel” on |
|
| page 27). |
|
| : The batteries may be discharged. |
|
| : It may be running on battery power. |
|
|
|
| Flashing | The UPS is testing the batteries as part of the automatic system test (see “Automatic |
|
| System Test” on page 31); or, you have started a timed shutdown (see Table 8 on |
|
| page 44). |
|
|
|
CHARGING | On | The UPS is charging its batteries. |
|
|
|
| Off | The battery charger is off; batteries are at full charge. |
|
|
|
| Flashing | Not applicable. |
|
|
|
BATTERY POWER | On | The UPS is providing power from its batteries; it is in the Inverter On mode. |
|
|
|
| Off | The UPS is providing conditioned power from the AC input power source, or the UPS is |
|
| off. |
| Flashing | The UPS is testing the inverter as part of the automatic system test (see “Automatic |
|
| System Test” on page 31). |
|
|
|
ALARM | On | The UPS is warning you that an alarm exists. If you have not silenced the alarm, the |
|
| beep sequence identifies the problem (see “Alarms” on page 59.) If you have a control |
|
| panel, an alarm message appears on its display. |
|
|
|
| Off | No alarm exists. |
|
|
|
| Flashing | Not applicable. |
|
|
|
26 | Powerware® FERRUPS FE/QFE UPS (500 |
