Powerware FE/QFE UPS manual UPS Startup, Startup for the FE and QFE 500 VA-3.1 kVA UPS

C H A P T E R 3

UPS STARTUP

This section provides step-by-step instructions for starting the Powerware FERRUPS UPS. Follow these procedures closely to avoid potential damage to your equipment or the UPS and to protect yourself and others from hazardous operating conditions.

Startup for the FE and QFE 500 VA–3.1 kVA UPS

To start the FE and QFE 500 VA–3.1 kVA UPS, use the following steps:

hd Confirm the equipment to be protected by the UPS is powered off.

id For FE Plug-Receptacle UPSs: Plug the UPS power cord into a power outlet.

NOTE If the plug does not match your receptacle outlet, ask your electrician to install the proper outlet.

For QFE Plug-Receptacle UPSs: Disconnect the power cord from the computer or other equipment to be protected by the UPS and plug it into the UPS. Plug the other end of the power cord into a power outlet.

NOTE Do not use the cord supplied with the UPS; this cord is for plugging the equipment into the UPS output receptacles.

NOTE If the plug does not match your receptacle outlet, ask your electrician to install the proper outlet.

NOTE If you need to order a UPS power cord, please call your service representative.

For Hardwired UPSs: Confirm that an electrician has completed and tested the connection to the proper power source and connected your protected equipment according to the

po poOpo AUPP–18 kVA) Installation Guide. Turn the AC line disconnect switch to the ON position.

Powerware® FERRUPS FE/QFE UPS (500 VA–18 kVA) User’s Guide : Rev A www.powerware.com 17