m
Entering Commands from a Terminal or Computer
To monitor or control the FERRUPS UPS from a terminal or computer, simply type in one of the commands and press [ENTER] (see Table 8). Use the following command syntax:
:type the command in uppercase or lowercase
:use the entire command or the short form (you can also abbreviate the command as long as you include the letters in the short form
:use a semicolon to separate more than one command on a line
Table 8. Commands
Command | Short | Password | Function |
|
| Form |
|
|
|
|
|
|
| |
alarmshelp | ah | None | chargermode command, you can change the charger mode: | |
S ows | list of all possible alarm messages, the audio code and letter for | |||
|
|
| each alarm and whether the alarm is active. | |
alarmlog | al | None | Displays Alarm Log. See “Alarm and Inverter Logs” on page 62. | |
alarmtest | at | None | Allows you to test the alarm function. Alarmtestsounds the User Test | |
|
|
| alarm (J). See page 61. | |
|
|
|
| |
alarmtest cancel | at c | None | Turns the Us Test alarm off. | |
|
|
|
| |
chargermode | chm | None* | use the extendedhistory or historycommands. | |
S ows the UPS battery charger mode. By entering a mode after the | ||||
|
|
| : charg | rmode off (chm f) or cha germode disable (chm d) = charger off |
|
|
| : charg rmode on (chm o) or cha germode enable (chm e) = charger on | |
|
|
| : charg rmode auto (chm a) = charger enabled if AC input voltage and | |
|
|
| battery voltage are acceptable |
|
|
|
|
|
|
clearalarms | ca | None | Clears all active alarms. |
|
|
|
|
| |
clearhistory | ch | None | Clears the minimum and maximum parameter values shown when you | |
|
|
|
|
|
clearpassword | cp | None | Clears the current password. |
|
|
|
|
|
|
commands | cm | None | Displays a list of all valid commands. |
|
|
|
|
| |
contdisplay | cd | Depends | Continuously displays the parameter that you are currently displaying. | |
|
| on | You can specify other parameters for the continuous | by entering |
|
| parameter | the name or number of each parameter after the contdisplay command. | |
|
| password |
|
|
|
|
|
| |
contstatus | cs | None | Continuously displays the Status information (see the statuscommand.) | |
|
|
|
|
|
*If you change parameter 39 to “Yes,” this command requires a User password.
44 | Powerware® FERRUPS FE/QFE UPS (500 |
