Powerware FE/QFE UPS manual Alarm and Inverter Logs, Reading the Alarm Log from a Control Panel

k	W	W	v h l	v s c
	b	l
T	–	Call	The UPS has detected a problem that	The UPS shuts down. Contact your service
		Service	requires service.	representative.
W	: – –	Fan Alarm	The fan has stopped.	The UPS may have shut down; if so,
				contact your service representative. If the
				UPS has not shut down, shut down your
				equipment or bypass the UPS; then, turn
				the UPS off and contact your service
				representative.

Alarm and Inverter Logs

Your FERRUPS UPS makes an entry in its logs every time it sounds an alarm or switches to inverter (battery power). This information can be helpful in diagnosing problems.

You can view the Alarm and Inverter Logs from either the UPS control panel or a terminal or computer that you have connected to the RS-232 port (see “Connecting a Terminal or Computer to the RS-232 Port” on page 41).

Reading the Alarm Log from a Control Panel

The Alarm Log is parameter 25. To display the Alarm Log from a control panel, follow these steps:

Press this key: Display shows:
[DISPLAY]	'LVSOD\￿
[2][5]	'LVSOD\￿	￿￿
[ENTER]	￿￿ $ODUP /RJ

The display scrolls through the 20 most recent entries in the Alarm Log. If you have not had 20 alarm conditions, the display scrolls through the entries FERRUPS has recorded. You can use the number keys as you view this scrolling display:

Use this key:	To do this:
[0]	Pause the scrolling and start it again.
[1] through [9]	Go to the next log entry.

62 Powerware® FERRUPS FE/QFE UPS (500 VA–18 kVA) User’s Guide : Rev A www.powerware.com