Oven light, To replace the oven light | Whirlpool SS385PEE instruction

CARING FOR YOUR RANGE

PART	WHAT TO USE	HOW TO CLEAN

Oven door glass	Paper towel and spray	• Make sure oven is cool.
	glass cleaner	• Follow directions provided with the
	OR	cleaner.
	Warm, soapy water	• Wash, wipe with clean water, and dry
	and a nonabrasive,	thoroughly.
	plastic scrubbing pad	• Wipe up food spills containing sugar as
		soon as possible after oven cools down
		(see the “Using the Self-Cleaning Cycle”
		section.)

Oven cavity	Self-Cleaning cycle	• See the “Using the Self-Cleaning Cycle”
		section.
	OR	OR
	Sponge and warm,	• Make sure oven is cool.
	soapy water on oven	• Remove oven bottom (see “Removing the
	bottom, when removed	oven bottom” earlier in this section).
		• Wash, wipe with clean water, and dry well.
	OR	OR
	Soapy steel-wool pad	• Make sure oven is cool.
	for heavily soiled areas	• Remove oven bottom (see “Removing the
	on oven bottom	oven bottom” earlier in this section).
		• Rinse well with water.

The oven light

The oven light will come on when you open the oven door. To turn on the light when the oven door is closed, press the Oven Light Switch on the control panel.

To replace the oven light:

1.	Unplug range or disconnect power.
2.	Remove the 3 screws in the bulb cover	Gasket Crystal Cover ring
	and lift off cover.
3.	Remove the light bulb from its socket.
	Replace the bulb with a 40-watt
	appliance bulb.
4.	Replace the bulb cover and screws
	(tighten screws).

5. Plug in range or reconnect power.

NOTE: To prolong bulb life, leave the oven light off during the Self-Cleaning cycle.

31

Image 31

Whirlpool SS385PEE important safety instructions Oven light, To replace the oven light, Oven door glass, Oven cavity

Contents

Part no C4020P030-2/4389869 Rev. a UseAndCare What to do if YOU Smell GAS Your safety and the safety of others is very important Important Safety Instructions Important Safety Instructions Control panel Parts and Features Push in control knob and turn counter Using Your RangeUsing the surface burners Surface burner markers Case of a prolonged power failure Burner heat settings Cookware tipsHome canning information Positioning racks and pans Display/clock Command padsFor best air circulation Electronic oven control Using the electronic Minute Timer Setting the clock To shut off repeating end of timer countdown signal Using the off/cancel padAudible signals To cancel the Minute Timer Baking/roasting Adjusting the oven temperature control Broiling Rare steaks and fish Broiling rack position chartBroiling tips Rack Position From Bottom Food Energy saving tips Using the electronic Mealtimer control Cook Time To start baking/roasting now and stop automatically Stop Time To delay start and stop automatically To cancel the Mealtimer control Setting Storage drawer Oven ventRemoving the storage drawer To verify the anti-tip chain is engaged Anti-tip chainReplacing the storage drawer Before you start Using the Self-Cleaning Cycle To start the Self-Cleaning cycle now Setting the controlsTo delay the start Self-Cleaning cycle To stop the Self-Cleaning cycle at any time When the oven locksWhen the Self-Cleaning cycle is completed When the oven reaches normal baking/roasting temperatures How the cycle works Special tips Surface burner grates and reflector pans Caring for Your RangeLift-up cooktop To replace burners To clean burnersSurface burners To remove burners To remove Removing the oven bottomTo replace Part What to USE HOW to Clean Cleaning chart Reflector pans Do not clean in Self-Cleaning cycleSurface burner Grates Oven cavity Oven lightTo replace the oven light Oven door glass Problem Possible Cause Solution If You Need Assistance or ServiceBefore calling for assistance … Lift off ports, are Yellow, or are Noisy when Turned off Burner makesPopping noise When on Control Not turn Self-Cleaning If you need service … If you need FSP replacement parts …If you need assistance … Page Whirlpool will not PAY for Gas Range WarrantyLength of Warranty Whirlpool will PAY for Full ONE-YEAR Warranty