Surface burners, To remove burners | Whirlpool SS385PEE specification

CARING FOR YOUR RANGE

Surface burners

To remove burners:

1.Lift up the cooktop, following instructions on the previous page.

2.Before cleaning, remove and throw away screws that hold each of the burners in place. The screws prevent the burners from moving during shipment. Remove the shipping screws.

3.Grasp burner head and tilt it to the right to release the two tabs from slots in the burner support.

4.Lift the end of the burner assembly, then pull away from the front of the range to free the air shutter from the gas valve orifice.

To clean burners:

1.Wipe off surface burners with warm, soapy water and a sponge after each use. To remove cooked-on food, soak the burners in a vinegar and water solution for 20 to 30 minutes. Scrub with a plastic scrubbing pad.

2.If ports are clogged, clean with a straight pin. DO NOT enlarge or distort the ports. DO NOT use a toothpick to clean the ports.

3.Before putting the burners back, dry them thoroughly by setting them in a warm oven for 30 minutes.

To replace burners:

1.Slip the air shutter over the gas valve orifice.

2.Lower the burner assembly and hook the tabs in the slots in the burner support.

Lighter					Burner ports
					Burner ports

port						Flash tube
port

Tab Ignitor

Burner support

Gas valve

orifice

Air shutter

27

Image 27

Whirlpool SS385PEE important safety instructions Surface burners, To remove burners, To clean burners, To replace burners

Contents

Part no C4020P030-2/4389869 Rev. a UseAndCare What to do if YOU Smell GAS Your safety and the safety of others is very important Important Safety Instructions Important Safety Instructions Control panel Parts and Features Push in control knob and turn counter Using Your RangeUsing the surface burners Surface burner markers Burner heat settings Cookware tips Case of a prolonged power failureHome canning information Positioning racks and pans Display/clock Command padsFor best air circulation Electronic oven control Using the electronic Minute Timer Setting the clock To shut off repeating end of timer countdown signal Using the off/cancel padAudible signals To cancel the Minute Timer Baking/roasting Adjusting the oven temperature control Broiling Rare steaks and fish Broiling rack position chartBroiling tips Rack Position From Bottom Food Energy saving tips Using the electronic Mealtimer control Cook Time To start baking/roasting now and stop automatically Stop Time To delay start and stop automatically To cancel the Mealtimer control Setting Oven vent Storage drawerRemoving the storage drawer Anti-tip chain To verify the anti-tip chain is engagedReplacing the storage drawer Before you start Using the Self-Cleaning Cycle Setting the controls To start the Self-Cleaning cycle nowTo delay the start Self-Cleaning cycle To stop the Self-Cleaning cycle at any time When the oven locksWhen the Self-Cleaning cycle is completed When the oven reaches normal baking/roasting temperatures How the cycle works Special tips Caring for Your Range Surface burner grates and reflector pansLift-up cooktop To replace burners To clean burnersSurface burners To remove burners Removing the oven bottom To removeTo replace Part What to USE HOW to Clean Cleaning chart Reflector pans Do not clean in Self-Cleaning cycleSurface burner Grates Oven cavity Oven lightTo replace the oven light Oven door glass If You Need Assistance or Service Problem Possible Cause SolutionBefore calling for assistance … Lift off ports, are Yellow, or are Noisy when Turned off Burner makesPopping noise When on Control Not turn Self-Cleaning If you need FSP replacement parts … If you need service …If you need assistance … Page Whirlpool will not PAY for Gas Range WarrantyLength of Warranty Whirlpool will PAY for Full ONE-YEAR Warranty