INSTALLATION
TEST THE UNIT PRIOR TO INSTALLATION
To prepare it for testing before installation in wall:
•Unit needs to be in the upright position for 24 hours before starting.
•Remove unit from box
•Place unit on tabletop
•Plug in unit to electrical outlet
•Plug in bottle sensor
•Turn on to test (Should be 10°F- 15°F across coils) approx.
•Turn off after test
•Remove bottle sensor
Electrical Needs
The WhisperKOOL Extreme System requires a dedicated
1.Match the electrical outlet to the plug provided on the WhisperKOOL unit.
2.Provide a dedicated circuit and wiring for the unit.
3.Provide a weatherproof plug for units connected outside.
Electrical Inlets
The unit is equipped with two power inlets: One is located on the right side of the unit; (inside the cellar) the other is located on the rear of the unit (outside of the cellar). Use the selector switch located on the right side of the unit to select which power inlet you would like to utilize. (Meaning if you would like to plug the unit into a socket outside of the cellar, set the selector switch to rear; if you would like to plug the unit into a socket inside of the cellar, set the selector switch to the front position. When placed in either position power can only enter the unit utilizing the power inlet you’ve selected.)
Plug your WhisperKOOL unit into a surge protector or power conditioner. As with any sensitive electrical equip- ment, the WhisperKOOL electrical equipment may be damaged by power surges and spikes. Power surges and spikes are not covered in the WhisperKOOL Extreme warranty.
WE RECOMMEND THAT YOU DO NOT USE A GROUND FAULT INTERRUPTER (GFI) WITH THIS PRODUCT.
In case the unit should lose power, press the reset button and attempt to turn the unit back on. Check the home/ main circuit breaker. If the unit does not respond properly, refer to the Troubleshooting section on page 34.
Front / Rear Power Switch
FRONT
REAR
Manual
Reset
P R ES
S
|
| E |
| S | |
| E |
|
R |
| |
TO |
|
|
T
Front
Power
Inlet
Page 15
