W i e b e T e c h L L C

Chapter 3 GUI Connection

3.1 GUI – http

ProSATA SS8 supports graphic user interface (GUI) to manage the system by any web browser. Be sure to connect LAN cable to the network. The ProSATA will automatically obtain an IP address if connected to a network that has DHCP support. Check the ProSATA’s LCD for this address (found on the bottom side of the unit). The GUI can be accessed by typing the IP address in the browser URL address bar, as follows:

http://192.168.0.200

If DHCP is not available on your network then manual configuration will be required. If connecting directly from the ProSATA to your computer then you will need a cross-over cable. You'll then need to set the IP of the ProSATA to something similar to the IP address of your computer: YYY.YYY.YYY.XXX (Ys being the same numbers as your computer's IP). More info on manually setting an IP address is found in section 4.4.1.

Upon clicking on any function for the first time, a dialog window will pop up to authenticate login name and password.

Login name: admin

Default password: 1234

3.2 RS-232 serial port

Use RS-232 serial cable to connect console port.

Default baud rate: 115200, 8 bits, 1 stop bit, and no parity.

Terminal type: vt100

Login name: admin

Default password: 1234

3.3 Remote control – secure shell

SSH (secure shell) is required for ProSATA SS8 to remote login. The SSH client software is available at the following web site:

SSHWinClient: http://www.ssh.com

Putty: http://www.chiark.greenend.org.uk

Host name: 192.168.0.200

Login name: admin

Default password: 1234

Note

Using ssh, the IP address has to be setup and the password is required for login.

ProSATA SS8 User Manual

- 10 -

 

 

Page 10
Image 10
WiebeTech SS8 user manual GUI Connection, GUI http