W O L F STEAMER MODULE U S E & C A R E
AUTOMATIC DRAIN O P E R AT I O N | TIMER O P E R AT I O N |
IMPORTANT NOTE: The steamer module must be installed with a drain connection and access to the drain through the base cabinet.
The touch pad operation is functional only while the unit is in Idle mode. The unit must be unlocked and not in operation. Refer to the illustration below.
To activate the drain:
1)Touch for 3 seconds. The unit will
beep, the light in the touch pad will illuminate and the drain valve will open for a period of 2 minutes. This should be enough time to drain a full capacity of water. This operation may be repeated as many times as needed to completely drain the steamer basin.
2)Touch again while in the drain mode operation to shut the drain valve. The
light in the touch pad will go out.
If you do not have a fixed drain connec- tion, use caution when draining hot water from the steamer basin to avoid burns. Use a
The control panel of the steamer module has an independent
To start the timer, touch the ”+” or
A warning beep will sound when the timer has 1 minute left and begins to countdown in seconds starting at 59.
A signal will beep when time has expired and will continue to beep every 30 seconds.
Touch to reset the timer.
touch pad |
touch pad |
Touch control panel
”+” and |
symbols |
Timer |
display |
Timer controls
12