A C C E S S O R I E S
Optional acces- sories are available through your Wolf dealer. To obtain local dealer information, visit the Locator section of our website, wolfappliance.com.
W O L F PRO WALL VENTILATION H O O D S
27" (686) DEEP WA L L H O O D S
S T E P 2 : WA L L P R E PA R AT I O N
Framing must be tied together and to ceiling joists to provide enough structural strength to support the weight of the hood and internal blower, if applicable.
Construct the wood wall framing flush with the wall studs and centered in the location that the hood will be mounted. Use the
After the wall surface is finished, secure the
If wall framing is not available, wall anchors must be used.
S T E P 3 : H O O D P R E PA R AT I O N
IMPORTANT NOTE: If a duct cover is to be used, follow instructions on page 21 before installing the wall hood.
Refer to the illustration below for the location of mounting holes for the 27" (686) wall hood.
The hood assembly is shipped with the
Remove the filters by pushing each filter up at the angle it is placed in, and rotate down. Remove the center filter first. Then take out the grease cups placed on the bottom edge of the hood coinciding with the bottom edge of the filters. Gloves should be worn to provide the proper grip when removing filters.
Detach the
Separate the transition from the
Reattach the transition to the
Attach the transition to existing ductwork with sheet metal screws and duct sealing tape.
|
| 91/2" (241) |
|
211/4" (540) | 10" (254) |
| |
|
|
| 41/2" (114) |
|
| * |
|
81/2" (216) |
|
| * |
|
| * | |
|
| 20" (508) | 41/2" |
|
|
| (114) |
8" | (203) | 13/16" (21) | * |
| |||
|
|
| |
*
*
41/2" (114) *
41/2" 
(114)
*
*Dimension is 2" (51)
Mounting holes for 27" (686) hoods
Shipping | |
Screws | Plate |
| Transition |
Rough-in plate installation
14
