Wolf W302210I installation instructions S Ta L L At I O N I N S T R U C T I O N S

I N S TA L L AT I O N I N S T R U C T I O N S

L OW- P RO F I L E A N D 2 4 " ( 6 1 0 ) H O O D S

Always install a roof or wall cap if you are not installing a remote blower. Connect 8" (203) round metal ductwork for low-profile hoods or 10" (254) round metal ductwork for 24" (610) deep hoods to the cap and work back towards the hood. Use duct sealing tape on joints between ductwork sections.

IMPORTANT NOTE: Do not use ducting smaller than 8" (203).

Wolf Pro wall hoods come standard with a backdraft damper included in the transition assembly. Local codes may require the use of an additional backdraft damper. Contact your local HVAC professional for specific require- ments. In cold weather installations, a back- draft damper is necessary to minimize the backflow of cold air into the room.

Local building codes may require the use of make-up air. Consult your local HVAC profes- sional for specific requirements in your area.

To reduce the risk of fire and electric shock, install this ventilation hood only with a blower manufactured by Wolf. Blower model numbers are listed on page 20.

ROOF CAP OR REMOTE BLOWER

10" ROUND DUCT

SOFFIT OR CABINET

OR DUCT COVER

18" (457)	WALL HOOD
HEIGHT OF HOOD

24" (610)

DEPTH OF HOOD

30" TO 36"

(762–914)

COUNTERTOP

TO BOTTOM OF

VENTILATION HOOD

36" (914)

STANDARD

FLOOR TO

COUNTERTOP

HEIGHT

DUCTWORK INSTALLATION

THROUGH ROOF

TRANSITION 221/4"W x 9"D TO 10" ROUND 10"H (INCLUDING FLANGES)

VERTICAL DISCHARGE

WALL CAP

OR REMOTE BLOWER

DUCTWORK INSTALLATION

THROUGH WALL

DISCHARGE COLLAR

HORIZONTAL

DISCHARGE*

Dimensions in parentheses are in millimeters unless otherwise specified.

*HORIZONTAL DISCHARGE IS APPLICABLE ON 24" (610) DEEP WALL HOODS USED WITH WBLOWER-60INT, WBLOWER-120INT OR ANY WOLF REMOTE BLOWER. WBLOWER-90INT

AND IN-LINE BLOWERS ARE NOT FOR USE IN HORIZONTAL DISCHARGE APPLICATIONS.

Ducting options for 24" (610) deep wall hoods

9