Woods Equipment BH7500 manual Install Rear Hanger Bracket, Install Rear Mount

SUB-FRAME INSTALLATION Cont’d

Install Rear Hanger Bracket

1.Install rear hanger bracket (6) to bottom of transmis- sion housing. Position bracket with the slots to the rear of the tractor. Secure using two cap screws (12) and hardened flat washers (13).

2.Torque these cap screws to 87 lbs.-ft. at this time.

2. 1004329 Rear mount

6.62977 Rear hanger bracket

12.16087 M14 x 1.5P x 35mm Cap screw

13.46070 9/16 Hardened flat washer, thick

Install Rear Mount

1.Slide round bar of rear mount (2) into slots of rear hanger bracket (Figure 6 & Figure 7).

2.Pivot rear mount upward and secure to tractor with 3-point lower link pins and hardware (Figure 8).

IMPORTANT

■Figure 8 is shown with PTO shield removed for clarification. Only remove PTO shield for modifica- tions described on 5.

12

6 13

DP1

Figure 6 Rear Hanger Bracket Installed

2

6

CD5915-1

13

12

Figure 7 Rear Hanger & Rear Mount

3-Point Lower

Link Pin

2

DP2

Figure 8 Rear Mount Installed

MAN0157 (10/12/01) Installation 7