3
2
1
DP2
Figure 2.
Roll the skid steer arms back until the tiller is com- pletely off the ground. Engage the parking break on the skid steer. Stop engine and relieve the back pressure in the auxiliary hydraulic system. Exit the skid steer.
Move the coupler pins to the engaged position. Hook up the auxiliary hydraulic hoses. Be sure they are routed to prevent any hose interference. Check the attach pins (4) to be sure they are fully engaged in the attach bracket as shown in Figure 3.
4
DP3
Figure 3.
TILLER DEPTH ADJUSTMENT
All tiller models have four depth settings. Moving the depth skid location allows the depth setting to be changed. Figure 4 shows the cutting depth for the four depth positions. When making adjustments, be sure that both skids are set at the same position.
To change the depth skid position, lower the tiller to the ground so the weight is supported on the tines. Remove the two bolts from each depth skid. Adjust the
depth skid for the desired cutting depth. Reinstall the two bolts and torque to 250
1.5.50" Cutting Depth
2.4.25" Cutting Depth
3.2.25" Cutting Depth
6.00" Cutting Depth if Skid is Removed
Figure 4.
TILLER OPERATION
■Read and understand the tiller and skid steer operator’s manuals before operating the tiller. Fail- ure to do so may result in death, serious personal injury or properly damage.
The tiller is a hydraulic powered attachment intended to cultivate soil. The tiller attachment operation is
The TL52 has an offset mounting configuration to allow the right tracks to be covered when the skid steer moves in reverse for finishing the tilling operation.
The performance of the tiller can vary significantly depending upon the way it is used. The tiller attach- ment requires a minimum hydraulic supply. For require- ments on each model see specifications on page 4.
MAN0003 (Rev. 11/30/2006) | Operation 11 |
|
|
