Woods Equipment TL52, TL73, TL84 manual Service, Depth Skid Assembly

7 8 9

6

DP10

Figure 19

Use a hoist to lift the drum. Make sure the coupler is aligned with the motor shaft and insert motor shaft into drum as shown in Figure 20.

DP6

Figure 20.

Install the motor housing into other side of the chassis. Install the motor housing (6) into one side of the chas- sis using four 1/2" x 1-1/2" bolts (7), eight 1/2" flat washers (8) and four 1/2" - 13 nuts (9) as shown in Fig- ure 19. Torque to 120 lbs-ft (163 N-m).

Note: It may be necessary to rotate drum to allow the splines on the coupler to align with the splines on the motor shaft.

DEPTH SKID ASSEMBLY

Install two 5/8" x 4-1/2" bolts (14) and two 5/8" washers

(15)in each depth skid (17) as shown in Figure 21. Slide the two bushings (16) onto the 5/8" bolts.

15

16 14

17

DP12

Figure 21.

Assemble the depth skid on either side of the chassis, using an additional two 5/8" washers (18) and two 5/8" nuts (19) for each side as shown in Figure 22. Torque to 240 lbs-ft (325 N-m).

18 19

DP13

Figure 22.

18 Service MAN0003 (Rev. 11/30/2006)