SAFETY RULES
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
(Safety Rules continued from previous page)
MAINTENANCE
Before leaving operator's seat, follow power unit manual instructions. Lower lift arms and put attachment on the ground. Stop engine, remove key, engage brake, and remove seat belt/operator restraint.
NEVER GO UNDERNEATH EQUIPMENT. Never place any part of the body underneath equipment or between moveable parts even when the engine has been turned off. Hydraulic system
•Service work does not require going under- neath.
•Read Operator's Manual for service instruc- tions or have service performed by a qualified dealer.
Do not modify or alter or permit anyone else to modify or alter the equipment or any of its compo- nents in any way.
Your dealer can supply original equipment hydraulic accessories and repair parts. Substitute parts may not meet original equipment specifica- tions and may be dangerous.
Do not allow bystanders in the area when oper- ating, attaching, removing, assembling, or servic- ing equipment.
Never perform service or maintenance with engine running.
Keep all persons away from operator control area while performing adjustments, service, or maintenance.
Tighten all bolts, nuts, and screws to torque chart specifications. Check that all cotter pins are installed securely to ensure equipment is in a safe condition before putting unit into service.
Make sure all safety decals are installed. Replace if damaged. (See Safety Decals section for location.)
Make sure shields and guards are properly installed and in good condition. Replace if damaged.
Do not disconnect hydraulic lines until all sys- tem pressure is relieved. Lower unit to ground, stop engine, and operate all hydraulic control levers.
Leak down or failure of mechanical or hydraulic system can cause equipment to drop.
STORAGE
Follow manual instructions for storage.
Keep children and bystanders away from stor- age area.
Alitec Tiller SR (Rev. 11/30/2006)
Safety 7
