DRUM INSTALLATION
Rotate the tiller chassis (1) so that it rests on the attach bracket as shown in Figure 17.
Figure 14. TL52 and TL73
Install motor housing (5) into one side of the chassis using four 1/2” x
(7) and four 1/2” - 13 nuts (8) as shown in Figure 15.
6 7 8
5
DP10
Figure 15.
Figure 16. TL84
1
DP12
Figure 17.
Insert one coupler (2) into each end of the drum as shown in Figure 18. Make sure the end nearest the hole is to the inside. Line up the hole in the drum (3) with the hole in the coupler and install one 1/2" x
Torque to 85
5
3
2
4
DP7
Figure 18.
Install the motor housing (6) into one side of the chas- sis using four 1/2" x
MAN0003 (Rev. 11/30/2006) | Service 17 |
|
|