OPERATION
Safety instructions are important! Read all attachment and power unit manuals; follow all safety rules and safety decal information. (Replace- ment manuals and safety decals are available from your dealer. To locate your nearest dealer, check the Dealer Locator at www.WoodsEquipment.com, or in the United States and Canada call
Power unit must be equipped with ROPS and seat belt/operator restraint. Keep seat belt/operator restraint securely fastened/engaged. Falling off power unit can result in death from being run over or crushed. Keep ROPS systems in place at all times.
■The operator is responsible for the safe opera- tion of this equipment. Operators must be instructed in and be capable of the safe operation of the equipment, its attachments and all controls. Do not allow anyone to operate this equipment without proper instructions.
Skid steers must be equipped with an auxiliary hydraulic system capable of supplying continuous flow for hydraulic motor operation.
PRE-OPERATION CHECK LIST
Owner’s Responsibility
___ | Review and follow all safety rules and decals. |
| See safety rules on page 5 and safety decals on |
| page 8. |
___ | Check that all safety decals are installed and in |
| good condition. Replace if damaged. |
___ | Check that all shields and guards are properly |
| installed and in good condition. Replace if dam- |
| aged. |
___ | Check that equipment is properly and securely |
| attached to skid steer. |
___ | Check that all hardware and cotter pins are prop- |
| erly installed and secured. |
___ | Do not allow riders. |
___ Keep all bystanders away from equipment work- ing area.
___ Check that all hydraulic hoses and fittings are in good condition and not leaking before starting power unit.
___ Check that hoses are not twisted, bent sharply, kinked, frayed or pulled tight. Replace any dam- aged hoses immediately.
___ Make sure power unit ROPS and seat belts are in good condition. Keep seat belt securely fastened during operation.
TILLER INSTALLATION
Read instructions in the skid steer operator’s manual for connecting and removing attachment.
Place the couplers in the disengaged position as shown in Figure 1. Rotate the skid steer attachment slightly forward and fully lower the lift arms.
DP1
Figure 1.
Pull forward to the attachment as shown in Figure 2. Make sure the outside of the skid steer attach (1) is aligned with the inside of the tiller attach (2). Continue to pull forward until the skid steer attach makes contact with the tiller attach. Raise the skid steer arms until the top of the skid steer attach contacts the top latch bar
(3) on the tiller.
10 Operation | MAN0003 (Rev. 11/30/2006) |
|
|