- 14 -
3.2.2 Raise the rear of the unit and support it with jack stands or equivalent support .
CAUTION
POTENTIAL HAZARD
♦ Raising the r ear of the unit for assembly relying solely
on mechanical or hydraulic jacks could be dangerous.
WHAT CAN HAPPEN
♦ The mechanical or hydraulic j acks may not be enough
support or m ay malfunction allowing the unit t o fall,
which could cause injury.
HOW TO AVOID THE HAZARD
♦ DO NOT rely solely on mechanical or hydraulic jacks
for suppor t . Use adequate jack st ands or equivalent
support.
3.2.3 Remove the wheel nuts from both sides of the unit and r etain for lat er use.
3.2.4 Install the two lower roll bar tubes.
a) Locate the left and right lower roll bar tubes.
b) Align lower roll bar t ubes along wheel motor channels as shown in Figure 2.
c) LOOSELY install lower roll bar har dware (four 3/8-16 x 1 capscrews, four
spring disk washers and four 3/8-16 whizlock nuts) from the bolt bag to the
tubes on each side as shown in Figure 2.
NOTE: Be sure the spring disk washer cone is installed t owards the head of
the capscrew.
FIGURE 2
LOWER ROLL BAR INSTALLATION
3.2.5 Install the upper u-shaped section of t he r oll bar . (Reference Fig ur e 3 for
alignment and inst allation instructions below):
a) Locate the latch pin assemblies (pin and hairpin connected with a lanyard).
b) Install a 1/2- 13 x 3 1/4 capscr ew in the washer on the lanyard of each pin
assembly.
Note: Make sure t he bent t ab in the washer is towards the head of the bolt.
b) Lightly oil the inside surfaces of t he ear -shaped plates at the upper end of
the lower roll bar tubes.