- 17 -
b) Remove the four 5/ 16-18 whizlock nuts from t he seat track st uds at the
bottom of the seat. Retain for use later.
c) Align the seat t r ack studs on the bot tom of t he seat with the holes in t he
seat f r am e. Place seat on top of t he frame and secure with the four 5/ 16- 18
whizlock nuts remove in step b).

3.7 INSTALL MOTION CONTROL LEVERS

3.7.1 Loosen and remove the two (2) 3/8” x 1” bolts and spr ing disc washers which
attach the m otion control levers to t he control arm shafts for shipping and t he
two (2) 3/8” x 1” bolts and spr ing disc washers which are screwed into the contr ol
arm shafts.
a) Install the left mot ion cont r ol lever ont o the control arm shaft ( See Figure 4)
on the lef t side of the console. Place the lever (with the mounting plate
towards the rear) on t he outside of the control arm shaft and secure with
the bolts and washers. Position t he lever so t he bolt s ar e in t he center of
the slots on the lever m ount ing plate and tig hten until snug. Repeat on
opposite side of unit .
NOTE: There are t wo lever height options available. Place the levers in the
top two holes to increase heig ht of the levers, or in t he bottom two holes to
decrease the heig ht of the levers.
If t he levers do not align with each other, when in the neutr al posit ion, (See
Figure 5) loosen t he har dware and make the appropriate adjustment by
sliding/t ilting the lever( s) forward or backward until properly aligned and
tighten har dware.
FIGURE 4 FIGURE 5
CONTROL ARM SHAFT LEVER ALIGNMENT
b) If the ends of t he levers hit against each other , while in the drive
position (levers rotat ed in as far as possible), make adj ustments by moving
the levers outwards to the neutral lock posit ion and carefully bending them
outward. Move them back to the dr ive position and check f or clear ance,
repeat if necessary.

3.8 POSITION DISCHARGE CHUTE

3.8.1 Loosen two (2) 5/16” nyloc nuts att aching discharge chut e. Lower the discharge
chute into position. Retighten nyloc nuts unt il chute is snug but can pivot freely.
3.9 SERVICE ENGINE
Engine is shipped with oil, check oil level and if necessary fill to the appropriate
level with SAE 10W-30 or 10W-40, AP1 ser vice class SF or SG for oper at ing in
temperat ur es above 0° F (-18° C). See Engine O per ator's Manual.
MOUNT PLATE TO
THE REAR & O U TS ID E
OF ARM SHAFT
MOTION
CONTROL
LEVER
LEVERS IN
ALIGNMENT