Model W1823 (Mfg. Since 9/10)
Remote Control
Reprogramming
Reprogramming the receiver on this machine is done with the machine connected to power. As a result, a hazard for shock, fire, or machine damage exists. ONLY a qualified electrician or service person should do this procedure.
This procedure covers how to reprogram the RF receiver to accept the new remote control frequency. Use these instructions if you ever replace either of these components, or convert the machine to operate on 220V. This procedure can also be used to control multiple models of this machine with one remote control.
To reprogram the remote control, do these steps:
1.DISCONNECT MACHINE FROM POWER!
2.Install a new battery in the remote control.
3.Remove the magnetic switch cover (Figure 37), and locate the receiver reset button shown in Figure 38.
4.CONNECT THE MACHINE TO POWER.
5.On the receiver (see Figure 38), use an insulated wooden or plastic dowel to press and hold the reset button until a triple beep is heard. The original remote control code is now erased.
6.Press and hold the reset button for
7.On the remote control, press and hold the "ON" button until a double beep is heard. The remote control has sent a new code to the receiver that has been accepted.
8.On the receiver, press the reset button for
9.DISCONNECT THE MACHINE FROM POWER, and reinstall the magnetic switch cover.
Receiver
(In Magnetic
Switch Box)
Figure 37. Remote control receiver
location.
RF Receiver
Unit
Reset Button
Figure 38. Remote control receiver.
SERVICE
