Model W1823 (Mfg. Since 9/10)
SETUP
22.Place the drum extension on top of the collection drum, and orient the window, vacuum hose port, and the clamp bolt, as shown in Figure 22.
23.Install and tighten the drum clamp, as shown in
Figure 22.
24.Thread the four swivel casters into the underside of the drum.
25.Fasten the 1⁜1⁄2" diameter vacuum hose onto the collection drum with the 13⁄4" hose clamp, as shown
Figure 22.
26.Place two
23.
27.Place the dust collection drum bag in the drum and roll approximately 2" of the bag over the edge of the drum.
28.Pull the release lever down to lift the drum cover, roll the drum under the lid, and push the lever upward to lower the lid on the drum (see Figure
24).
Note: The lid is not designed to rest on top of the drum with any real force, nor is it designed to snap into place to create a seal. Instead, a tight seal is established by the vacuum created when the dust collector is in operation.
Drum Clamp |
Window |
Vacuum Hose |
Figure 22. Drum and drum extension
positioning and installation.
Acorn Nut
Figure 23. Handle installation.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Lid Raised |
|
|
| Lid Lowered |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
29. Place the canister bag around the bottom edge of | Figure 24. Drum positioning at front of |
the canister, and clamp it in place with the quick | machine. |
release bag clamp, as shown Figure 25. |
|
Congratulations! Assembly is complete. |
|
|
|
|
|
|
|
