Woodstock W1823 manual Magnetic switch box

Model W1823 (Mfg. Since 9/10)

5.Loosen the two plastic screws that secure the cover of the magnetic switch box shown in Figure 41, then remove the cover.

6.Locate the incoming power and outgoing motor cords (shown in Figure 42) inside the magnetic switch box. Carefully note the destination of all of the wires associated with these two cords, and record their position so that you can return them to the corre- sponding positions in the 220V magnetic switch box assembly later.

7.Loosen all of the terminal screws that have wires from the power cord or motor cord attached, then remove the wires.

8.Remove the entire 110V magnetic switch box assem- bly from the dust collector frame.

9.Install the 220V magnetic switch box assembly (purchased separately) in place of the 110V switch removed in Step 8, then re-install power and motor wires on the 220V switch box assembly in the same positions that they were in on the 110V switch. Tighten all terminals.

10.At this point, the new remote control receiver inside your new magnetic switch must be reprogrammed so it can communicate with your old hand-held control. To do this, complete the Remote Control Reprogramming procedure on Page 29.

11.Close the magnetic switch box cover and secure it with the two plastic screws.

-33-

Loosen

Figure 41. Magnetic switch box.

GND							Outgoing
							GND
							Motor Cord
							Rewired f	220V
Magnetic		L1			L2		GND
	A	L1
Switch						L2
		L1/1	L2/3	L3/5	7		7V0V120V0V Transformer 50/60Hz
Box			Contactor		ON	L2
		SDE MA-15 110V
DX^e\k`Zjn`kZ_Yfo
Xjj\dYcp dljk Y\
Assembly
i\gcXZ\[ n`k  ))'M
df[\c]fi))'Mlj\%
		T1/2	T2/4	T3/6	8		GND
					B
					6
								Stop Switc
Incoming				Reciever
			Remote Control
Power				Circuit Board
				SJE-MSR-PCB
Cord
				Hot				Ground
			110 VAC
				Neutral			Rewired
							for 220V	Hot

	220
Ground	VAC

5-15 Plug	Hot 220V 6
(Prewired)	(As Reco

Figure 42. Magnetic switch.

SERVICE