Woodstock W1823 manual Assembly, To assemble the dust collector, do these steps

Model W1823 (Mfg. Since 9/10)

SETUP

Assembly

Before beginning assembly, refer to the inventory list and group all fasteners with their intended components. Doing this will make assembly easier.

When assembling this machine, tighten fasteners using hand tools only. Avoid using air or electric impact tools because fasteners can easily be over-tightened, causing them to dig into the paint, strip threads, and over- compress gaskets—causing flanges to deform and leak. Using silicone sealant at connection points is optional.

To assemble the dust collector, do these steps:

1.With the help of another person, place the blower housing on its side carefully as not to scratch the paint.

2.Fasten the three upper legs to the leg support bosses on the blower housing with (12) 5⁄16"-18 x 1⁄2" button head cap screws, as shown in Figure 9.

3.Thread the caster wheels into the lower legs and tighten.

4.Insert and fasten the leg connectors in the lower legs using (12) 5⁄16"-18 x 1⁄2" button head cap screws, as shown in Figure 10.

Leg Support
Boss
	Blower
	Housing
Upper Leg	Button
	Head
	Cap
	Screw

Figure 9. Upper leg installed on blower

housing leg support boss.

Figure 10. Lower leg connector and swivel

caster installation.

5.Insert the leg connectors into the upper legs, as shown in Figure 11, and secure together with (12)

5⁄16"-18 x 1⁄2" button head cap screws.

Note: You will notice that the bolt pattern in the upper legs and the leg connectors (Figure 11) is off–center to ensure that the lower legs can only be installed in the correct direction.

Upper Leg	Leg	Lower Leg
	Connector

Figure 11. Inserting a lower leg into an

upper leg.

-14-