![](/images/new-backgrounds/1096517/9651761x1.webp)
Connecting the DC Cables
Connecting the DC Cables
Do not remove the terminal nut
Do not place anything between battery cable lug and terminal surface. Assemble exactly as shown.
Copper Compression Lug | Aluminum Box Lug |
Figure 3-5 DC cable lug examples
Consult Figure
To make the DC connections:
1.Cut the cables to the correct length with enough insulation stripped off so you can properly install the type of terminals you will be using.
The terminals on the DC end are designed to fit up to 500 MCM
2.Attach the connectors to both cables.
If using compression lugs, attach the terminals to both cables using the crimp tool recommended by the manufacturer of the ring terminals. There must be no stray wire strands protruding from the terminal. If using box lugs, attach the lug to the XPower Inverter 3000 Plus first, then insert the wire and tighten the set screw to the torque recommended by the lug manufacturer.
3.Route the DC supply cables from the battery bank to the inverter.