Mounting the Inverter

Mounting the Inverter

Dimensions and Knockout Locations

The dimensions of the inverter and the mounting bracket and some of the knockout locations on the wiring/disconnect box are shown in Figure 2-1 and Figure 2-2.

Four 27 or 35 mm (1 or 1-3/8 inch) dual knockouts are provided on the back and bottom of the unit to accommodate wiring.

Four 27 mm (1 inch) conduit holes on the sides of the wiring/disconnect box (two on each side) are filled with plastic plugs, which can be removed to insert conduit nipples as required for multiple inverter installations. One or two of these side conduit holes may be used to accommodate Xanbus network cables connected between multiple inverters.

13.7 (5 3/8)

 

55

2.7 cm (1")

(21 5/8)

 

conduit holes

69.9

with threaded

(27 1/2)

 

caps, both

72.6

sides

(28 9/16)

11 (4 )

6.52 (2 9/16)

40.3 (15 7/8)

27.9 (11)

5/16

Dual 3.5 cm or 2.7 cm

6.15

(2 7/16)

6.2 (2 7/16)

(1 3/8" or 1") knockoutsDual 3.5 cm or 2.7 cm (1 3/8" or 1") knockouts

 

5.2 (2)

27.9 (11)

All measurements

in cm (inches).

 

Figure 2-1Dimensions of GT Inverter and Knockout Locations

975-0320-01-01

2–5