Installation
Step 2: Mounting Your Inverter
Mount your inverter before you connect any wires or cables.
For your convenience, the inverter dimensions are provided in
Figure 2-9 on page 2–23.
WARNING: Fire hazard
To meet regulatory requirements, the TS400 must be mounted on a flat horizontal surface with the front panel in the upright position.
To mount your TS400:
1.Turn the On/Standby switch on the front panel of the inverter to Standby ( 
) position.
2.Select an appropriate mounting location and orientation. See “Choosing a Location” on page
3.Hold the inverter against the mounting surface, mark the position of the mounting screws, and then remove the inverter.
OR
Use “Inverter Dimensions” on page
You can also download a
4.Pilot drill the four mounting holes.
5.Fasten the inverter to the mounting surface with four #10 hardware fasteners.
