OS/2 Warp Server (LAN Server) Network
OS/2 Warp Server
(LAN Server) Network
Quick Install Steps | 1 Print the Configuration Sheet. Details are in this | |
|
| document in Appendix A: Print The Configuration |
|
| Sheet. |
| 2 | Check the Configuration Sheet and verify that both |
|
| TCP/IP protocol and proper connector are enabled on the |
|
| printer. |
| 3 | Create a new printer to load print drivers. Details for this |
|
| are found in the Technical Information Guide. |
| 4 | Create a network printer resource and its permissions. |
| 5 | Start LPRPORTD/LPRMON, ping printer, open EPM and |
|
| send a print job to the printer. |
| 6 | Check the print job for print quality. If print quality |
|
| problems exist, use the print quality section of your |
|
| printer System Administrator Guide to correct the |
|
| problem. |
| 7 | If your print job did not print, see the Troubleshooting |
|
| section for your operating system in the Technical |
Information Guide to correct the problem.
