OS/2 Warp V4.0 and OS/2 Warp Connect 3.0
OS/2 Warp V4.0 and
OS/2 Warp Connect 3.0
Peer-to-Peer Network
Quick Install Steps | 1 |
| 2 |
3
4
5
6
7
Print the Configuration Sheet. Details are in this document in Appendix A: Print The Configuration
Sheet.
Check the Configuration Sheet and verify that both TCP/IP protocol and proper connector are enabled on the printer.
Create a new printer to load print drivers. Details for this are found in the Technical Information Guide.
Create a printer share and its access permissions (sharing and connecting).
Start LPRPORTD/LPRMON, ping printer, open EPM and send a print job to the printer.
Check the print job for print quality. If print quality problems exist, use the print quality section of your printer System Administrator Guide to correct the problem.
If your print job did not print, see the Troubleshooting section for your operating system in the Technical Information Guide to correct the problem.
