Xerox 701P91273 manual NIC Settings, Ethernet, TokenRing, Read Only Settings

NIC Settings

Ethernet:

Connector Type (bnc, rj45, autoselect)

TokenRing:

Connector Type (db9, rj45, autoselect)

Ring Speed (4mbs, 16mbs)

Routing (yes/no -- source routing: enabled/disabled)

Card Address (TokenRing physical address can be set)

Reset Printer (yes/no -- resets NIC and enables any NIC changes)

Reset network card settings to factory defaults (yes/no -- resets NIC to default settings)

Read Only Settings

The following is a list of displayable NIC parameters (Read Only)

NIC Firmware Revision (NICs firmware revision)

Processor Speed (NIC processor speed)

Ethernet Address (physical layer address)

13-6 XPrint UNIX SYSTEM PRINTER DRIVER INSTALLATION