Appendix C Setting up APPSOCKET

Appendix C Setting up APPSOCKET

1.Press On Line on the Control Panel. Verify the LED to the left of the button is OUT.

2.Press Menu . The ON-LINEmessage will disappear and TOP MENU should be displayed.

3.Press Up+ until <COMMUNICATIONS> appears on the Display Panel and then press Enter.

The APPSOCKET default settings are:

<APPSOCKET> = <ENABLE> = <YES>

<MODE> = <AUTOSELECT>

NOTE: The Mode options are not applicable for APPSOCKET. The setting should always remain at AutoSelect.

To change the settings, follow these steps:

4.Press Up+ until <NETWORK SETUP> is displayed and then pressEnter.

5.Press Up+ until <TCP/IP> is displayed and then pressEnter.

6.Press Up+ until <APPSOCKET> is displayed and then pressEnter.

7.Press Enter while <ENABLE> is displayed.

To enable APPSOCKET pressEnter while <YES> is displayed.

To disable APPSOCKET pressUp+ until <NO> is displayed and then press Enter.

8.Press On Line . Verify the LEDto the left of this button switchesON.

XPrint UNIX SYSTEM PRINTER DRIVER INSTALLATION

15-3

Page 47
Image 47
Xerox 701P91273 manual Appendix C Setting up APPSOCKET, <Appsocket> = <Enable> = <Yes>, <Mode> = <Autoselect>